Before installing PCC for SharePoint, you must first install Prizm Content Connect. This section will guide you through installing Prizm Content Connect in a multi-server topology. We will install Prizm Content Connect to a single server, which is shown as “Prizm Content Connect Server” in the parent section. After installation, a one-time only configuration needs to be performed.

To install Prizm Content Connect on the Prizm Content Connect Server, follow these steps:

1. Start the installer from any location on the Prizm Content Connect Server.
2. Click the Next button to continue:
   

3. Carefully read the information contained in the License Agreement form before making a decision to accept the terms of the agreement. Choose I accept the terms in the License Agreement to accept the conditions outlined in the License Agreement and then click the Next button to continue the installation, or click Cancel to exit the installation process:
   

4. After clicking Next, the Destination Folder form is displayed. Specify the destination directory where the Prizm Content Connect product should be installed or choose the default installation destination directory. Then click Next:
   

5. [64-bit Only] If you are installing Prizm Content Connect on a 64-bit system, you will have the option to select the Architecture for your system. Once you have selected an architecture, click the Next button to proceed:
   

6. In the IIS Configuration Dialog, the installer will prompt you to configure the Plus and HTML5 product samples within IIS. Since this is not a requirement for PCC for SharePoint, deselect this option.
7. Additionally within the IIS Configuration Dialog, the installer gives you the option to re-register ASP.NET 4.0 with IIS. Since this is not required for PCC for SharePoint, deselect this option. Click Next to move forward with the installation:

8. The Custom Setup screen allows you to define what components of Prizm Content Connect you want to install. 

   Clients components are not required for PCC for SharePoint (HTML5 and Plus).

   Once you have made your selections, click the Next button to proceed to the next step:

   

9. The next step in the installation process allows you to define the account that will be used to run the Prizm Service that is installed on the system. The dialog will default to the user running the installation, but you can enter in a user name or use the Browse button to select a user from the local system or domain. Once a user has been selected, the password for the user account will need to be entered into the dialog.

   The user account specified will be given the “Log on as a Service” permission. This permission is required in order for a user account to be used as the service account.

   Once you have entered in all of the appropriate information, click Next to continue. If the password is not correct an error dialog will be displayed noting that the password is not correct:

   

10. The Ready to Install Prizm Content Connect dialog is the final configuration dialog that launches the installation process. To install the product with the defined settings, click the Install button:
    

11. The Installer will unpack the product, and lay out and configure the product as defined in the configuration dialogs:
    

12. About three-quarters of the way through the installation, the installer will launch the Prizm Licensing Utility. Follow the steps outlined in this utility to license the product for use. Please refer to the Prizm Licensing Utility instructions for help on obtaining a license:
    

13. After the Prizm Licensing Utility completes, the installer will continue setting up your system with Prizm Content Connect. Once the configuration is completed, a dialog will notify you that the installation is complete. There will be an option to launch the product release notes if you wish to view them directly after the installation. Click Finish to exit the Installer:
    
14. Perform the one-time only configuration steps for Installing PCC for Multi-Servers.